Pool Maintenance

Pool filter pump should run a minimum of 8-10 hours per day during the swimming months and 6-8 hours per day during the non swimming months
Brush pool for dirt as necessary. Brush entire pool a minimum of once a week
Note: Filter pump should run during possible freezing temperatures to avoid damage to pool plumbing

Liquid Chlorine

If water temperature is above 70 degrees, add 1 gallon of chlorine every other day
If water temperature is below 70 degrees, add 1 gallon of chlorine twice a week
Always add chemicals while pool equipment is running
Never add any chemicals to spa

8 Gallons of Liquid Chlorine
4 Gallons Muriatic Acid
Largest bag you can find of Diatomaceous Earth
Diatomaceous Earth Scoop
3” Chlorine Tablets - 1 large bucket (Only if you have an inline chlorine tablet feeder)

Please leave a hose out for the plasterers to fill the pool with, If possible use two hoses
Wrap the end of the second hose with a cloth as the plasterers will have done with the first
Begin filling the pool and spa no sooner than 2 hours after the plasterers have left
Use low pressure initially. When the water has risen a foot or two you must increase the water pressure
Once you begin filling the pool or spa, do not stop filling until water is approximately 1” onto the tile in the spa and 3” onto the tile in the pool
Continue filling even if the plasterers have not installed the lights
Do not let water from spa spill into the partially filled pool
Do not get in pool or spa while they are filling
Do not use the auto fill to fill pool. It will not be operable until start-up
Do not attempt to run equipment or turn on pool/spa lights. They will not work until start-up
All remaining clean-up will be done at start-up